Owatrol Compo-Clean Cleaner Degreaser for Composite Wood
Owatrol Compo-Clean Cleaner/Degreaser can be used to horizontal or vertical surfaces found externally and is ideal for grooved decking where there is a high level of ground in dirt.
Owatrol Compo-Clean Cleaner/Degreaser is a water-based, environmentally friendly, composite wood cleaner that has been specifically developed for removing all types of dirt, grease, stains, moss and pollution from the surface.
Best Uses
Owatrol Compo-Clean Cleaner/Degreaser is ready to use directly from the bottle and can be applied immediately, simply and effectively as soon as you get it. Owatrol Compo-Clean Cleaner/Degreaser is fast acting and removes most kinds of common staining within 5 minutes of application. Suitable for exterior use on all types of composite wood such as composite decking, WPC decks, composite cladding, composite balustrade and horizontal and vertical composite timber.
- Water based - Environmentally friendly
- Removes surface and ground in dirt
- Fast acting - from 5 minutes depending on the condition of the surface being cleaned
- Easy to apply
- Does not contain solvents or paraffin. Will not attack plastic pool liners, stone, glass
Application
Owatrol Compo-Clean Cleaner/Degreaser should be shaken or stirred before application. Do not dilute. Apply between + 5°C to + 35°C. Do not apply in direct sunlight or on hot wood. Always work the entire length of a board to a logical break. On vertical surfaces, clean from bottom to top and rinse from top to bottom to avoid streaking.
Apply a thick layer of Owatrol Compo-Clean to the area to be cleaned. Large areas, should be cleaned in smaller sections. Leave the product to work for 5 minutes (longer if necessary depending on the nature of the dirt and contamination). Scrub with a stiff nylon or synthetic brush. Rinse with plenty of fresh clean water using the highest pressure source available or use a power washer (max 50 bars). If required repeat above procedure - difficult / stubborn staining. Allow surface to dry 2/3 good drying days before applying chosen finish.
Ideal for use in a system with Owatrol CompoXell.
Surface and Environment
Owatrol Compo-Clean Cleaner/Degreaser can be used to horizontal or vertical surfaces found externally and is ideal for grooved decking where there is a high level of ground in dirt. Cladding and other garden furniture can also be cleaned using this quick performing solution.
Preparation
- Always test a small area first
- Protect all areas not to be cleaned, plants, shrubs etc including and especially aluminum parts
- Wear suitable protection - gloves (rubber/nitrile), goggles or visor, clothing.
Directions for use
- Apply a thick layer of COMPO-CLEAN to the area to be cleaned. Large areas, should be cleaned in smaller sections
- Leave the product to work for 5 minutes (longer if necessary depending on the nature of the dirt and contamination)
- Scrub with a stiff nylon or synthetic brush
- Rinse with plenty of fresh clean water using the highest pressure source available or use a power washer (max 50 bars). If required repeat above procedure - difficult/stubborn staining
Technical Info
| Components: | Single Pack |
| Type: | Water Based |
| Finish: | - |
| Stock Colours: | Yellow-orange |
| Tintable: | No |
| VOC Content: | < 1 g/l |
| Volume Solids: | - |
| Suitable Substrates: | Composite Wood, Composite Cladding |
| Application Method: | Brush, Roller, Hose or Pressure Washer |
| Theoretical Coverage: | 5-10 m2/litre |
| Pot Life: | - |
| Overcoatable: | Allow surface to dry 2/3 good drying days before applying chosen finish |
| Cleaner / Thinner: | Clean up with water |
| Shelf Life: | 1 year in original unopened container |
| Packaging: | Available in 1, 2.5 and 15 Litres |