SKU: ID26158

Part A: UN1866 (Class: 3, Pk Grp: II), Part B: UN3106 (Class: 5.2), Part C: Non Hazardous

LRS RapidRoof Crack and Joint Filler

A fast curing, high strength, trowel applied, three component resin mortar, for rapid and permanent repairs to roofs.

Available in 10 Kg in Light Grey

* These colours are for guidance only. Variations between output devices can misrepresent the appearance of an actual colour. Also, we strongly advise that you order your complete paint requirements simultaneously to ensure a uniform batch colour.

2. Size

3. Select a Qty

As low as:

£123.81

Inc VAT £148.57

PRODUCT DETAILS

LRS RapidRoof Crack and Joint Filler is a fast curing, high strength, trowel applied, three component resin mortar, designed for rapid and permanent repairs to roofs and balconies.

Best Uses

LRS RapidRoof Crack and Joint Filler is an ideal fixing solution for repairing roofs and balconies. Formulated to be used within LRS RapidRoof systems.

Resilient
Very good chemical resistance
Excellent adhesion
Fast curing, even at low temperatures
Impact and abrasion resistant
Frost resistant and impervious to water
Excellent mechanical properties

Application

Remove all laitance, grease, oil, dust and other contaminants to provide a sound, clean substrate.

PRIMING:
The prepared surface shall be primed by the application of LRS RapidRoof Primer. The mixed LRS RapidRoof Primer should be applied by brush or roller at a nominal rate of 1kg per 3-4m², depending upon surface profile. Allow the primer to cure for a minimum of 60 minutes.

MIXING:
LRS RapidRoof Crack and Joint Filler is supplied as a three component product consisting of the BASE component, the CATALYST component and the AGGREGATE component. The contents of the BASE and CATALYST component should be thoroughly mixed together and the AGGREGATE then introduced. A low speed drill stirrer will be suitable.

APPLICATION:
LRS RapidRoof Crack and Joint Filler should be applied by trowelling to ensure good compaction and a tight finish. The material should not be feather edged.

CURING:
Allowing a minimum cure time of 1 hour ~ at 20°C prior to foot trafficking and 2 hours at 20°C prior to full trafficking.

TECHNICAL

Components:	3 Pack
Type:	Resin Mortar
Finish:	N/A
Stock Colours:	Light Grey
Tintable:	No
VOC Content:
Volume Solids:
Suitable Substrates:	Concrete, old Felt, Asphalt, OSB3, Metal, Old Fibreglass, Single Ply
Application Method:	Trowel
Theoretical Coverage:	1.5kg / 2kg per m2
Wet Film Thickness (WFT):
Dry Film Thickness (DFT):	1.5 - 2mm
Induction Time:	-
Pot Life:	20 minutes at 20°C
Touch Dry:
Overcoatable:
Fully Cured:
Cleaner / Thinner:
Shelf Life:	6 months unopened
Packaging:	Available in 10 Kg