PPG Steelguard 651

Waterborne intumescent coating for fire protection of structural steelwork.

Available in 20 Litres

* These colours are for guidance only. Variations between output devices can misrepresent the appearance of an actual colour. Also, we strongly advise that you order your complete paint requirements simultaneously to ensure a uniform batch colour.

2. Size

3. Select a Qty

As low as:

£207.00

Inc VAT £248.40

PRODUCT DETAILS

PPG Steelguard 651 is a one-component, thin-film, waterborne intumescent coating for fire protection of structural steelwork. It provides up to 120 minutes protection from cellulosic fires.

Best Uses

PPG Steelguard 651 can be used in the following segments:

Fire Protection
Infrastructure & Rail
Airports
Cellulosic Fire Protection
Commercial Buildings
Stadiums & Venues

Steelguard 651 is suitable for C1, C2 and C3 internal environments (ISO 12944); for dry internal (C1) environments no topcoat is required.

Application

Approved primer must be sound, dry and free from any contamination.

The recommended application method is with an airless spray. Stir thoroughly until homogenous and free of lumps. Note that adding too much water will result in reduced sag resistance and slower cure.

TECHNICAL

Notes

Provides up to 120 minutes protection from cellulosic fires
On-Site application
Up to 700 microns (28.0 mils) DFT in a single coat
Suitable for C1, C2 and C3 internal environments (ISO 12944); for dry internal (C1) environments no topcoat is required
Tested and assessed to EN13381-8, BS476-20/21 and GB14907
CE Marked product, ETA 15/0524
Assessed to ETAG 018-2 for durability classifications Z1, Z2 and Y

Technical Info

Components:	Single Pack
Type:	Waterborne Intumescent Coating
Finish:	Matt
Stock Colours:	White
Tintable:	No
VOC Content:	max. 0.2 g/kg
Volume Solids:	70 +/- 3%
Suitable Substrates: Steelwork
Application Method:	Airless Spray. Brush or Roller should only be used on small areas (touch up and repair)
Theoretical Coverage:	1.00 m2/l for 700 microns
Wet Film Thickness (WFT):	-
Dry Film Thickness (DFT):	200 - 700 microns (8.0 - 28.0 mils) per coat
Induction Time:	-
Pot Life:	-
Touch Dry:	2 hours at 20°C
Overcoatable:	After minimum of 16 hours at 20°C
Fully Cured:	-
Cleaner / Thinner:	Tap water (normally no thinner required)
Shelf Life:	12 months from date of production unopened
Packaging:	Available in 20 Litres