Rustoleum Hard Hat Metallic Topcoats 2111 2115 2116
Rustoleum Hard Hat Metallic Topcoats 2111 2115 2116 are fast drying acrylic resin aerosols based on metallic pigments. Provides a bright metallic appearance with the durable protection of a standard topcoat.
Best Uses
Rustoleum Hard Hat Metallic Topcoats 2100 should be applied over Rustoleum Hard Hat 2169 or 2182 Primers or properly prepared painted substrates. These aerosols can also be recoated with Rustoleum Hard Hat 2500 Clear. Ideal for small maintenance jobs or for touch up.
- Metallic spray: nice finish, good protection
- For bare metal and galvanised steel
- Usable as topcoat on zinc primers and galvanised
- Finish with transparent topcoat for the best result
- Ideal for machinery, pumps, toolboxes, etc.
- Available in sparkling, gloss and stainless steel
- Heat-resistant up to 100°C
Application
Rustoleum Hard Hat Metallic Topcoats 2111 2115 2116 should be used in light industrial exposures, normal humidity and interior applications. Remove dirt, grease, oil, loose rust and all other surface contaminants by appropriate means. Prime or spot prime with the recommended Rustoleum Hard Hat 2169 or 2182 Primers. Sand intact coatings to provide a proper key for adhesion. The surface must be clean and dry during application. Remove cover cap. Shake vigorously for at least one minute after the rattle of mixing ball is heard. Shake frequently during use.
Hold can at least 25 cm from surface. Use back and forth motion keeping can parallel with surface. Ensure that can is in motion when spray button is pressed to avoid runs and sags. Apply several thin layers at a few minutes interval to achieve adequate coating thickness. After use turn can upside down and press spray button for 2 - 3 seconds to clean valve.
Notes
- Heat Resistance: 100°C (Dry heat)
Technical
| Components: | Aerosol |
| Type: | Fast drying short oil soya alkyd |
| Finish: | Metallic |
| Stock Colours: | Sparkling Aluminium, Bright Aluminium, Stainless Steel |
| Tintable: | No |
| VOC Content: | 842 g/l |
| Volume Solids: | - |
| Suitable Substrates: | Should be applied over Hard Hat 2169 / 2182 Primers or properly prepared painted substrates |
| Application Method: | Aerosol |
| Theoretical Coverage: | 2.5 m² per spray can at 25 μm dry (1.5 m² for 2115 and 2119) |
| Wet Film Thickness (WFT): | 100 μm |
| Dry Film Thickness (DFT): | 25 μm |
| Induction Time: | - |
| Pot Life: | - |
| Touch Dry: | 15 minutes at 20°C |
| Dry to Handle: | 30 minutes at 20°C |
| Overcoatable: | Within 1 hour or after 48 hours |
| Fully Cured: | 3 days at 20°C |
| Cleaner / Thinner: | - |
| Shelf Life: | Minimum of 5 years from date of production in unopened cans, if stored in dry, well ventilated areas. |
| Packaging: | Available in packs of 6x 500ml Aerosols |