Tor SP Stabilising Sealer AK602
Tor Stabilising Sealer AK602 is a low viscosity alkali resistant solution for the binding or stabilising of friable or highly porous masonry surfaces prior to finishing in a conventional masonry paints.
A low aromatic white spirit based coating, specially formulated to stabilise chalking and flaking paint on walls before the application of a conventional masonry paint.
Best Uses
Suitable as a dust sealer for leaving a glossy finish for friable concrete floors as well as an excellent binder for exterior walls.
Application
For Masonry: Remove all loose or flaking paint or render using a wire brush. Repair as required and leave to dry. Treat areas suffering from moss or algae with a suitable fungicidal solution. Ensure surface is dry before use. Apply using a brush and airless spray.
For Concrete Floors: Clean prior to remove laitance, oils etc. Use an acid etch solution or surface preparer to remove any existing coatings. Ensure surface is dry before use. Apply using a brush and airless spray.
| Components: | Single Pack |
| Type: | Solvent Based |
| Finish: | Gloss |
| Stock Colours: | Clear |
| Tintable: | No |
| VOC Content: | Cat IIA/h. EU limit 750g/l (2010) Max 585g/litre |
| Volume Solids: | 25% |
| Suitable Substrates: | Highly porous masonry surfaces, floors |
| Application Method: |
Masonry: Brush or airless spray. Floors: Brush, roller or airless spray |
| Theoretical Coverage: | 9 square metres per litre |
| Wet Film Thickness (WFT): | - |
| Dry Film Thickness (DFT): | Nominal 28 microns dft |
| Induction Time: | - |
| Pot Life: | Not applicable |
| Touch Dry: | 2 hours at 20°C |
| Overcoatable: | After minimum 16 hours to maximum 48 hours at 20°C |
| Hard Dry: | 6-8 hours at 20°C |
| Cleaner / Thinner: | Thinner not normally required. Use Tor TH10 for cleaning equipment |
| Shelf Life: | 5 years in unopened containers |
| Packaging: | Available in 5 Litres |